Nova-243 Outdoor LTE TDD Base Station Installation Guide
14
3.6.2 Connect GPS Antenna
1. Insert GPS jumper into cold shrink tube.
2. Connect one end of the GPS jumper to the GPS antenna.
3. Push the cold shrink tube to the top joint and pull out the strip.
4.
Connect the other end of the GPS jumper to
GPS
interface of the base station,
which also need weatherproof protection.
3.6.3 Connect RF Cable
1. Open the dust cap of
ANT0
and
ANT1
interface.
2. Insert RF cables into cold shrink tube.
3. Connect one end of the two RF cables to
ANT0
and
ANT1
interface of the base
station and tighten them with wrench.
4. Push the cold shrink tube to the top joint and pull out the strip.
5. Connect the other end of the RF cables to the external antenna, which also need
weatherproof protection.
3.6.4 Connect Ethernet Cable
1. Connect the Ethernet cable to
ETH0
interface in the wiring cavity.
2. Lay Ethernet cable along the wire groove, and stretch out the wiring cavity from
ETH0
hole.
3.6.5 Connect Power Connector
Because it is not sure that the distance between the installation site and the power
supply device, the two ends of power adapter are bare terminal end. The operators need
to make power cable according to the actual conditions on installation site, and assemble
power plug and power terminal on two ends of power adapter.
Strip 12mm insulating layer with wire stripper, which is used for connection to connector.
It is recommended that the power cord length is kept below 100m (330 feet).
The connection steps of power cable is as follows.
1. Assemble power plug.
The power plug will be installed on the end of input direction. Refer to the
identification on power plug, connect live wire, neutral wire, and ground wire to
