Common troubles trouble shooting methods
To facilitate your use and maintenance of sauna room, the following common troubles trouble
shooting methods are listed for identification.
Troubles
Causes of troubles
Trouble-shooting methods
The machine does
not start when
electrified
1. The fuse is burned.
2. The wire connection terminal
become loose.
3. Not good contact in the connection
wire between the controller and the
steam engine.
1. Change the fuse (on the shell 0.8A/ 250V)
2. Plug tight the wire connection terminal
3. Make sure the steam engine and the
controller come into good contact
Electricity leakage
switch
breaks
automatically
1. The wire connector is dampened
or damaged.
2. The heating tube breaks
1. Check whether the wire connector is
dampened or damaged, and dry with
dryer if dampened.
2. Change a heating tube.
When the machine is
started, hot water
comes out with little
or no steam
1. The water drainage valve is broken.
1. hange a water drainage valve.
The display screen
on the control panel
does not display
1. The power wire is not connected
well or not in good contact. The
connection plug between the
control panel and the electrically-
controlled box becomes loose.
2. Trouble with plugboard.
1.
Check whether the connection plug
between the control panel and the
electrically-controlled box has become
loose, and whether the power circuitry
has good contact.
2. change a plugboard.
Water leakage
1. The water pipe connector becomes
loose or the pipe breaks
2. Water leakage in the water input
valve or the water drainage valve
1. Tighten the loose connector, and change
the broken pipe.
2. Change the water input valve or the
water drainage valve.
No steam when
starting the
machine
1.
No electricity.
2.
No water.
3.
The set temperature is too low
4.
Trouble with wire.
1. Check the power supply
2. Check the water input pipe and water
input valve
3. Reset the temperature
4. Contact the distributor
The steam does not
come out, the water
sounds in the
machine
1. The steam pipe is jammed.
1. Cut power supply to check whether
the steam pipe is smooth.
The light can not
be turned on
The display box
displays normally
with no steam
input
1. Too much pressure inside the steam
engine, so the system breaks for
heat protection.
2. Wire is broken for heat protection.
1. Check the steam transport pipe and
restore automatically after heat
protection becomes cool.
2. Check the heat protection wire to make
sure the connection is good.
1. The fuse is burned.
2. The light is broken
3. The wire is broken
4. The plug does not have good contact
1. Change the fuse (on the shell 1A/250V)
2. Change a light bulb.
3. Change wire.
4. Cake the contact good.
GEN3-1
