Bagela
Bagela
Bagela
Bagela
asphalt recycler
asphalt recycler
asphalt recycler
asphalt recycler
BA 7000F / BA 10000
BA 7000F / BA 10000
BA 7000F / BA 10000
BA 7000F / BA 10000
2
2
Operating instruction - short version
Setting-up of asphalt recycler:
-
Before uncoupling the recycler from the towing vehicle, put chocks against the wheels and
apply the hand brake.
-
Let the rear props down to the ground and secure them with pins.
-
With the aid of the spirit level at the chassis, level out the recycler into horizontal position by
turning down the forward propping jacks.
-
Do not place the unit below overhead power lines, parts of buildings or trees to avoid fires.
Putting recycler into operation:
-
Start engine and bring it to full speed.
-
Engage the tumbler driving system.
Burner operation:
-
Caution! Do not start the burner unless the tumbler is turning.
-
Set burner to 1st firing stage (switch position 2).
-
After about 2 minutes, when the flame has stabilised, set burner to 2nd firing stage (switch
position 3).
-
Set thermostat to the required temperature.
I. first burner stage max. 180°C:
red pointer
II. second burner stage max. 150°C:
green pointer
Charging:
-
Fill asphalt into the recycler until the reading of the hydraulic oil pressure gauge is
- at 80 bar for processing asphalt lumps, or
- at 60 bar for processing asphalt fines.
DO NOT OVERFILL THE TUMBLER TO AVOID EXCESSIVE SMOKE EMISSION!
Discharging:
At the beginning of asphalt reprocessing there may be a delay in true temperature reading
due to the fact that the temperature of the charge is measured via the soak heat.
-
Make sure the first batch of reprocessed asphalt is discharged 10 minutes after start-up,
irrespective of the temperature reading.
Warning:
Load becomes inflammable, should sojourn duration dwell.
-
During continuous operation, keep the contents of the tumbler to a level corresponding to
80 bar (for asphalt lumps) or 60 bar (for asphalt fines) on the hydraulic oil pressure gauge,
keep the burner firing at its maximum rate (second stage) and discharge the reprocessed
asphalt continuously.
Stopping operation:
-
Switch off the burner (to stage 1 – burner fan blowing)
-
Make sure the tumbler is empty.
-
Stop the tumbler drive so that the outlet gate is in low position.
-
Leave the engine running and the burner fan blowing (burner switch on 1) until the tumbler
has cooled down to 100 °C.
Type of oil to be used: light fuel oil. Consumption rate: 5 kg/t
