BAFANG DP C18.UART, Display Manual

Page: 13 / 20

13 DISPLAY MANUAL DP C18.UART
USER SET
⑹ “TRIP Reset” --- set reset function for
single-trip distance
Briefly press (<0.5S) or to select “TRIP
Reset”,and then briefly press (<0.5S) .
This moment, briefly press (<0.5S) or
to switch between “NO”and“YES”. TRIP Re-
set includes maximum speed (MAXS), aver-
age speed (AVG), single-trip distance (TRIP).
After confirmation, briefly press (<0.5S)
again to save the set and exit back to the
“TRIP Reset”. Briefly press
for two times
(interval time is less than 0.5S) to exit the
main interface, or select “BACK”
→
“EXIT”
to exit back to the main interface. The data
is not reset automatically when turn off the
display or turn off the power of the bicycle.
⑺ “AL Sensitivity” --- set light sensitivity
Briefly press (<0.5S) or to select “AL
Sensitivity”, and then briefly press (<0.5S)
. This moment, briefly press (<0.5S)
or to switch level of the light sensitivity
between “0”/“1”/“2”/“3”/“4”/“5”/“OFF”.
“OFF” means close the function. Level 1 is
the weakest light sensitivity and level 5 is
the strongest light sensitivity. Select the level
desired and briefly press (<0.5S)
again to
save the setting and exit back to “AL Sensi-
tivity”. Briefly press
for two times (interval
time is less than 0.5S) to exit back to main
interface or select “BACK”
→
“EXIT” to exit
back to main interface.
⑻ “Password”--- access password setting
Briefly press ( < 0.5S) or to select
“Password” and then briefly press (<0.5S)
. This momen, briefly press (<0.5S)
or
to select “Start PassWord” and then briefly
press (<0.5S)
again. Briefly press (<0.5S)
or to switch between “OFF”/“ON”, the
below is the specific way of switching.
Starting password:
Enter into “Start PassWord” interface and
select “ON”. Briefly press (<0.5S)
, and
then it show input password in the interface.
This moment, briefly press (<0.5S)
or
to switch numbers “0-9”, and then briefly
press (<0.5S)
to confirm input number.
After input, it show input password again
in the interface. Repeat the above step to
input password again. If the password is
same with the previous time, the system
will prompt it is successful to set password,
otherwise it need to repeat the first step
to input the new password and then re-
confirm.
After setting the passwrod, the interface
exit back automatically to original interface
within two seconds. Briefly press
for two
times (interval time is less than 0.5S) to exit
back to main interface or select “BACK”
→
“EXIT” to exit back to main interface.