BAFANG DP C18.UART, Display Manual

Page: 15 / 20

15 DISPLAY MANUAL DP C18.UART
USER SET
Cancel password access:
Enter into “Start PassWord” interface to
select “OFF” and then briefly press (<0.5S)
. This moment, it prompt input password
in the interface. If inputing wrong pass-
word for ten times, the display will turn off
automatically. After inputing right password,
it prompt it is successful to close password in
the interface. Two seconds later, it exit back
automatically to the original interface. Briefly
press
for two times (interval time is less
than 0.5S) to exit back to the main interface
or select “BACK”
→
“EXIT” to exit the main
interface.
⑼ “Set Clock”--- time setting
Briefly press ( < 0.5S) or to select “Set
Clock” and then briefly press (<0.5S)
. The time is represented in the 24-hour
system. Cursor stays at the first digit of the
clock. Briefly press
or to select “0-2”
and then briefly press (<0.5S) to confirm
the selection. This moment, the cursor
switch to the second digit of the clock. Brief-
ly press
or to select “0-9”, and then
briefly press (<0.5S) to confirm the selec-
tion. And the cursor will switch to the first
digit of the minute. Briefly press
or to
select “0-5”, and then briefly press (<0.5S)
to confirm the selection. The cursor will
switch the second digit of the minute, and
then briefly press (<0.5S)
or to select
“0-9”. Briefly press (<0.5S) to save the
selection and exit back to “Set Clock”. Briefly
press
for two tiems (interval time is less
than 0.5S) to exit back to the main interface
or select “BACK”
→
“EXIT” to exit back to the
main interface.
• Enter into “Information” interface
Enter into “SETTING” interface and briefly
press (<0.5S)
or to select “Informa-
tion” and briefly press (<0.5S) to confirm
and enter into the interface. It can check all
content in the interface“Information”, but
can’t use the display to modify the content.
⑴ “Wheel”and“Speed Limit”check
Enter into “Information”interface and it
display the data of “Wheel” and “Speed
Limit”. User can use BAFANG’s BESST tool
to connect the display and PC to modify the
data. Briefly press (interval time is less than
0.5S)
for two times to exit back to the
main interface or select “BACK”
→
“EXIT” to
exit back to the main interface.