UniMod 01/I
7
B)
The parametering adapter with RS232 port, which can be
plugged instead of an interface module.
This adapter is no more available.
1. First disconnect the modem from the supply
(
important!
) and remove the interface mod-
ule.
2. Set the switch to left position "
01L", as
shown in the picture:
Position "
01L".
3. Insert the 7 pole plug of the parametering
adapter instead of the interface module. The
notch must point upwards.
4. Then connect the 25 pole plug (RS232) to
the PC port and switch on the voltage supply
at the modem.
5. The UniMod 01/I can now be programmed with the software UniModSet.
6. After programming switch off the UniMod and insert the interface module carefully again.
Summary of Contents for UniMod 01/I
Page 4: ...UniMod 01 I 4 ...
Page 15: ...UniMod 01 I 15 13 Dimensions Wall mounted housing DIN 43861 2 ...
Page 16: ...UniMod 01 I 16 ...