Operating Manual BaehrTec S2000
English– V101 – Status 07/2015
Page 27/52
Spray level
The selected spray level is shown here in writing and as a bar diagram. The bar diagram
also shows you if the spray function is currently active or not.
For more information, please refer to the previous section.
Refill control
Should the liquid tank be empty (as soon as the filling level is below the sensors) this will be
indicated on the monitor with the filter control symbol. In this case you must refill the spray
liquid.
Please always bear in mind:
As soon as the handpiece motor is running the air/water cooling of the titanium handpiece is
always automatically switched on (hardly noticeable).
This was a conscious design decision since this prevents the handpiece from getting warm.
Should the device indicate the need for refilling, operation will be limited to a speed of
max. 10,000 rpm without spray function, as the handpiece will no longer be water
cooled. Therefore always ensure there is enough liquid in the tank.
Service control
The BaehrTec S2000 has a servicing interval indicator. The service interval is 905 hours,
and refers to the operating hours of the handpiece motor as of the delivery/the last service.
You
must
send your device for servicing when the service key lights up on the display (or
within 24 months; this time interval is not displayed by the device) to avoid elaborate and
costly repairs and comply with the test regulations of your medical device according to VDE
0751-1.
The service interval is actually 900 hours. But as your device already has
meter readings at the time of delivery, as described in the following
section, we have incorporated a buffer of 5 hours for you.
Foot pedal
This symbol appears on the display as soon as the optionally available foot pedal is
connected.
Handpiece light
It will be indicated on the display whenever you switch on the light on the handpiece.
Please observe that the light on the handpiece only goes on when the light
is switched on and the handpiece motor is
also
running.
Should the handpiece motor not be running yet and the light is switched
on, then the light will light up automatically as soon as the handpiece moor
is switched on.
Should the light be on and the handpiece motor switched off then the light
will go off automatically after approx. 10 seconds (in case you do not
switch it off manually beforehand), so that the handpiece does not heat up
because of the super-bright LEDs.
