Installation & Operation Manual
Installation Procedure
NOTE: The utility is usually responsible for proper positioning of a the Transceiver. For optimum reception and
transmission, locate the Gateway in line-of-site view of the desired endpoints.
1.
Unpack the Gateway Transceiver.
2.
Screw a receiving antenna into each side of the Gateway (as shown in Figure 1).
3.
Tighten the antennas to the full o-ring compression by hand.
MMK Bracket Mounting
This mounting equipment is sized to mount the Gateway Transceiver on a 2-5/8-inch maximum diameter mast.
1.
Open the two bags of mounting equipment.
2.
Place two bolts (3/8-16 X 5 inches) through the holes in the top and bottom of the transceiver. Use the side holes for
horizontal installation.
3.
Place a clamp onto the bolts.
4.
Place a lock washer and nut onto each bolt.
Figure 2: Attach Hardware
5.
Tighten the two nuts with a 9/16" or adjustable wrench.
(1-11)
Page 7
