Installation & Operation Manual
Battery Installation/Replacement
In the event a battery replacement is required, please complete the installation steps as detailed below.
1.
Remove enclosure cover by unscrewing four, corner cover screws and discard the cover (the cover will not be used
again).
Cover on
Cover Off
Figure 15: Enclosure Cover Removal
2.
Squeeze the connector latch on the battery connector on the circuit board and clarefully pull on the connector to
remove it from the circuit board pins contacts. Do NOT pull on the connector wires. If the connector is stuck, it may
need to be gently rocked back and forth while pulling.
Figure 16: Battery Connector
3.
Remove battery from unit and safely discard (see "Battery Disposal" on page 16).
Figure 17: Battery Removal
Connector
Latch
(1-11)
Page 15
