Mounting the Gateway
Banding Mounting
Banding mounting equipment is sized to mount the gateway on a 2-1/2…24 inch outer diameter pole .
OTEE:
N
Installation of banding mounting requires the use of the BAND-IT tool (PN: 66042-006) or equivalent BAND-IT tool as
recommended by BAND-IT .
MPORTANT
I
When using the banding mounting kit for the gateway, use BAND-IT Idex installation practices. Refer to
www.band-it-idex.com/en/Literature/Tool_Instructions/P05886.pdf
for more information. This is especially applicable when
mounting on a non-tapered vertical pole, as the banding could loosen over time resulting in the unit sliding down the pole.
Figure 14: Banding and locking equipment
Figure 15: BAND-IT tool
1 . To mount the gateway on a pole, gather the banding and locking equipment .
2 . Locate the BAND-IT tool and supplied installation instructions .
3 . Follow the installation instructions enclosed with the BAND-IT tool for attaching the gateway receiver to a pole .
4 . Using a 1/2 inch wrench, apply the recommended torque for the 5/16-24 screw that attaches the gateway bracket to
the BAND-IT banding . The recommended torque is 144…168 inch-pounds (12…14 foot-pounds) .
Figure 16: Gateway shown with BAND-IT mounting hardware
Banding mounting is complete .
Page 16
April 2015
GXY-UM-00760-EN-01
