Mounting Hardware
Mounting Bracket
Machined with multiple holes to accommodate different mounting options, the mounting bracket is the largest part of the
gateway backplate . Mounting holes are labeled for V-block, banding and wall mounting options . The bracket also has 1/4 inch
and 3/8 inch grounding points (see
Figure 7
) which can be used if needed .
Figure 7: Mounting bracket
Mounting Options
The circular hole pattern on the mounting bracket can be used to accommodate mounting the gateway on an angled beam
or pole, if necessary .
The gateway can also be mounted on a wall . The mounting bracket has four 0 .28 inch holes marked for this option .
OTEE:
N
For a wall mount, customers must supply the mounting hardware suitable for the substructure on which the gateway
is mounted .
For mounting options, all gateway installation considerations must be observed . See
"Specifications" on page 6
and
"Installation Tools and Materials (Customer-supplied)" on page 8
.
TX/RX Antenna Bracket
The TX/RX antenna bracket is used for
mounting the TX/RX antenna . When shipped,
the TX/RX antenna bracket is attached to
the top of the mounting bracket
with three
locknuts using the holes indicated in
Figure 8
.
Other holes on the bracket can be used to
accommodate a variety of mounting options .
Figure 8: TX/RX antenna bracket
Used to Mount Backhaul
Antenna Bracket
Used to Mount TX/RX
Antenna Bracket
Grounding Points
Page 11
April 2015
GXY-UM-00760-EN-01
