![background image](http://html1.mh-extra.com/html/badger-basket/modmag-m2000/modmag-m2000_installation-and-operation-manual_3416953012.webp)
Data management
Page 10/23
MID_M2000_BA_02_PB_1612
6. Data management
The Profibus
®
DP interface is based on the Profibus
®
PA profile v3
.
0 and supports the
following blocks:
One physical block – contains parameters defined in PA profile v3.0
One transducer block – contains parameters defined in PA profile v3
.
0 in addition to
meter specific parameters
.
One analog input function block – contains one fixed channel, flow rate [User Units]
6.1 Physical block
The physical block contains general device setup parameters
.
It is important to describe
the details of the DIAGNOSIS and DIAGNOSIS_EXT parameters of the physical block.
Below is the definition of the supported bits of the DIAGNOSIS parameter.
Bit
Bit mnemonic
Supported
Bit description
0
DIA_HW_ELECTR
Yes
Hardware failure of electronics
1 DIA_HW_MECH
—
—
2 DIA_TEMP_MOTOR —
—
3 DIA_TEMP_ELECTR —
—
4 DIA_MEM_CHKSUM —
—
5
DIA_MEASUREMENT
Yes
Failure in measurement – sensor
failure, set if there is a failure over
ModBus
®
.
6 DIA_NOT_INIT
—
—
7 DIA_INIT_ERR
—
—
8 DIA_ZERO_ERR
—
—
9 DIA_SUPPLY
—
—
10
DIA_CONF_INVAL
Yes
Configuration invalid –
Configuration mismatch between
the Profibus
®
DP daughterboard
and the sensor electronics
11
DIA_WARMSTART
Yes
Reset occurred within last 10
seconds
12
DIA_COLDSTART
Yes
Power cycle occurred within last 10
seconds
13 DIA_MAINTENANCE —
—
14 DIA_CHARACT
—
—
15 IDENT_NUMBER_VIOLA
TION
Yes
Wrong identity number
16-30 —
—
—
31
EXTENSION_AVAILABLE Yes
Extension status is available
Summary of Contents for ModMag M2000
Page 24: ...Compliance Page 22 23 MID_M2000_BA_02_PB_1612 7 Compliance...
Page 26: ......
Page 27: ......