BEGIN
Install bolt with screws supplied and drill 5/16" hole for bolt to extend into door frame.
2
Place bolt onto
OO
in open position with bolt end 1/4" down from frame.
Bolt is open when loop is contacting base
(Fig A)
.
Mark and pre-drill holes for screws.
1
LEFT
DOOR
PARTS REQUIRED:
DOOR
1" (2,5 cm)
x1
x4
5/16" (0,8 cm) Drill Bit
Fig. A
x4
Loop contacts
base.
PRE-DRILL
(4) HOLES
2 x 3 x 69"
1/4" with bolt in open
position.
OPEN POSITION,
Spring is loose.
5/16" drill for bolt:
1" deep.
OVER DOOR FRAME
OO
LOCATE AND PRE-DRILL HOLES TO AVOID SPLITTING WOOD
35-1/2"
(90 cm)
FINISH
Install hasp on right door and latch on left door. Bottom edge of hasp is
35-1/2" (90 cm) up from bottom edge of door trim. Measure and mark locations and
install with 3/4" screws as shown
(Fig B)
.
3
x7
x1
3/4" (1,9 cm)
Fig. B
3/4" (1,9 cm) Screw x7
DOOR HARDWARE
43