Owner’s Manual Play Set
OWNER PS-2010
Rev. 10/21/2009
Please refer to the Assembly section of the Assembly Manual for Maximum Fall Height.
Positioning Your Playcenter
1.
The Playcenter is designed to be installed on a level surface
by an Adult
with an Adult helper
. Place in a
flat area of your yard to minimize ground preparation.
2.
Choose a level location for the equipment. This can reduce the likelihood of the play set tipping over and
loose-fill surfacing material washing away during heavy rains.
3.
Place the equipment not less than
6 ft
from any structure or obstruction such as a fence, garage, house,
overhanging branches, laundry lines, or electrical wires.
4.
Provide enough room so that the children can use the equipment safely. For example, for structures with
multiple play activities, a slide should not exit in front of a swing.
5.
It is a good idea to place your Playcenter in an area that is convenient for adults to watch children at play.
6.
Create a site free of obstacles that could cause injuries – such as low overhanging tree branches, overhead
wires, tree stumps and/or roots, large rocks, bricks and concrete. Additional suggestions in the Suggested
Playground Surfacing Section.
7.
Do not build your playset on top of surfacing material.
8.
Locate bare metal platforms and slides out of direct sunlight to reduce the likelihood of serious burns. A
slide that faces north will receive the least direct sunlight.
9.
Separate active and quiet activities from each other. For example, locate sandboxes away from swings or
use a guardrail or barrier to separate the sandbox from the movement of the swings.
Suggested Playground Surfacing
Playground equipment should never be placed on hard surfaces such as concrete or asphalt.
Do not install loose fill surfacing over hard surfaces such as concrete or asphalt.
Shredded bark mulch, wood chips, fine sand and fine gravel, are added as shock absorbing
materials after assembly. If used properly these materials can absorb some of the impact of a
child’s fall.
All surface material should extend a minimum of 6 feet in all directions around the play area.
Do not apply playground surfacing until after the unit is completely constructed. Playset
should not be built on top of surfacing.
Use containment, such as digging out around the perimeter and/or lining the perimeter with
landscape edging.
Installations of rubber tiles or poured-in-place surfaces (other than loose-fill materials)
generally require a professional and are not “do-it-yourself” projects.
Shall use Playground Surfacing Materials (other than loose-fill material) which comply with the
safety standard ASTM F1292 Standard Specification of Impact Attenuation of Surfacing
Materials within the Use Zone of Playground Equipment.