D-BA-0000305.4.10
Installation
Operating instructions
OI-22
V05 / September 07, 2010
4.2 Installation notes
The ambient conditions must be regard. (
Table 19, Page OI
)
The screws on the D-Sub connectors must be tightened.
The switch cabinet wall must be equipped with a sufficient installation cutout for the
assembled device according to the device dimensions.
The material thickness at the installation cutout should be
≥
2 mm.
Chapter 7.3 ''Dimensional drawings'', Page OI
For optimum interference protection, the device should be fixed to the place of
installation.
The front panel must be seated flat on the bare (permanently conductive)
mounting frame (e.g. on the machine).
The use of electrically conductive sealing material can improve contacting. Effects
such as corrosion must be taken into account.
Type of fixing
Tension clamps are provided for installation. Hook the tension clamps into the
openings on the device.
Fig. 9: Tensioning clamp