PCA
3 Manual
0024-9473 Rev 3
55
Logging Intervals and Durations
Logging Intervals
Logging Durations
1 second
5 minutes
5 second
10 minutes
10 second
15 minutes
15 second
30 minutes
30 second
1 hour
1 minute
2 hours
2 minutes
5 hours
5 minutes
10 hours
10 minutes
24 hours
48 hours
5.12.2. Turning On Data Logging
IMPORTANT:
Before turning ON data logging and starting the data
logging process, the analyzer should already be set up to perform a
combustion test (see Performing a Combustion Test section on
page 47).
Turn ON data logging as follows.
1. Display the MAIN MENU by pressing the
MENU (F2)
button. If
necessary, press ESC until MENU appears above
F2
.
2. Use the ▲▼ buttons to highlight SETUP, and then press
ENT
to display
the SETUP MENU.
3. Use the ▲▼ buttons to highlight LOGGING, and then press
ENT
to
display the LOGGING screen.
NOTE:
The amount of memory available for storing new
data is displayed in the LOGGING screen (maximum of
500 locations). If previous logging sessions are stored, and
additional memory is needed, clear the logging memory
(see Clearing Memory section on page 60).
NOTE:
At no time will new logging data over write old
data. Logging will stop when available memory is filled.
4. Use the ▲▼ buttons to highlight YES (turn logging ON).
5. Press
ENT
to make the selection and display the LOGGING INTERVAL
screen.
Summary of Contents for PCA3
