Microprocessor Module Replacement Kit for the Remote Display
3015-5577 Rev 2
5
Figure 4. Option B Installation
NOTE
: As a guide, align the larger hole on the microprocessor module with the top of the snap-in
spacer. If aligned properly, the pins will align with the main board socket and the hole in the
microprocessor board will align with the top connector of the snap-in spacer.
WARNING
: Be sure not to skip or offset the pins to the socket.
5. Ensuring that the pins are properly aligned and the snap-in spacer is in place and properly aligned, press the
microprocessor module firmly into the socket while simultaneously securing it to the snap-in spacer.
6. Close the door to the RD and secure the two screws.
7. Apply power to the RD and verify that it performs its initialization procedure.
8. Continue with Section 6.
6. Reconfiguring the Remote Display
IMPORTANT
: A reset to factory defaults occurs automatically on the first boot up with the new module. Be
sure to adjust the time, date, and communications settings afterwards. You may also choose to reconfigure
any settings you may have recorded earlier in this process.
Refer to the Remote Display Instruction Manual originally shipped with your unit for detailed information about RD menus,
menu navigation, and configuration settings. If you no longer have the manual that shipped with your device, the standard
RD manual may be downloaded from the Bacharach website at
www.mybacharach.com
. If you have any questions, you
may contact Bacharach’s Customer Service Department.
∇
∇
∇
