MGS-150 Manual
24
6309-9000 Rev 2
IMPORTANT:
Failure to test or calibrate the unit in
accordance with applicable instructions and with industry
guidelines may result in serious injury or death. The
manufacturer is not liable for any loss, injury, or damage
arising from improper testing, incorrect calibration, or
inappropriate use of the unit.
IMPORTANT:
Before testing the sensors on-site, the MGS
must have been powered up and allowed to stabilize.
IMPORTANT:
The testing and/or calibration of the unit must
be carried out by a suitably qualified technician, and must be
done:
•
in accordance with this manual
•
in compliance with locally applicable guidelines and
regulations.
Suitably qualified operators of the unit should be aware of the
regulations and standards set down by the industry/country
for the testing or calibration of this unit. This manual is only
intended as a guide and, insofar as permitted by law, the
manufacturer accepts no responsibility for the calibration,
testing, or operation of this unit.
The frequency and nature of testing or calibration may be
determined by local regulation or standards.
EN378 and the F-GAS Regulation require an annual check in
accordance with the manufacturer’s recommendation.
NOTE:
For improved accuracy and response, the instrument
should be zeroed and calibrated in the environment in which
it is being installed.
There are two concepts that need to be differentiated:
•
bump test
•
calibration.
Summary of Contents for MGS-150
