IAM-100 and Controller Manual
24
6209-9000 Rev 2
State
Operating Instructions
Errors
Should an alarm occur:
•
the green LED stays on
•
the red LED on the relevant channel comes on
•
the relays operate
•
the horn operates (can be muted by key switch)
•
the output to a master or upstream panel
operates to indicate
there is a fault
downstream.
Figure 11. External Components of the Controller
NOTE:
If all of the red LEDs are blinking approximately
every 5 seconds on a master panel, then remove the link on
Jumper position JP3 as this should be in the disabled
position on a master panel (factory default setting is
disabled).
Access
Screws
(2 Places)
Summary of Contents for IAM-100
Page 7: ...IAM 100 and Controller Manual 6209 9000 Rev 2 7 Figure 3 Sample Architecture Diagram ...
Page 14: ...IAM 100 and Controller Manual 14 6209 9000 Rev 2 Figure 6 Controller Housing ...
Page 34: ...IAM 100 and Controller Manual 34 6209 9000 Rev 2 ...
Page 35: ...IAM 100 and Controller Manual 6209 9000 Rev 2 35 ...