MGS-250 Manual
20 6490-9000
Revision
4
Step
Mounting Procedure
3
Wall Mount
Attach the MGS-250 base to
the mounting surface using
two #6 screws (provided)
through two of the mounting
holes, being careful not to
over-tighten the screws.
Refer to Figure 6 for the
locations of mounting holes on
the base.
Junction Box Mount
Attach the MGS-250 base to
the junction box (using
mounting hardware provided
with your junction box)
through the two junction box
holes. Refer to Figure 6 for
the locations of the two
junction box mounting holes
on the base.
4
Unless you are ready to wire the device (see section 3),
carefully snap the cover onto the base unit.
Figure 5. Initial Housing Separation
www.calcert.com
1.888.610.7664
0
5
10
15
20
25
30
