Fyrite INSIGHT
9
Inspect the flue-gas hose for cracks. If a hose is defective, replace the entire
probe assembly.
Before using the analyzer, check that the Water Trap / Filter is dry and
not dirty. If necessary, dry out the trap and replace the filter element per
Section 6.2.
Perform the following steps to connect the probe assembly to the Fyrite
INSIGHT:
1. Push the probe’s sample-gas hose onto the GAS inlet fitting.
2. Push the probe’s draft hose onto the “+” pressure fitting.
3. Push the probe’s thermocouple into the T-STACK jack
IMPORTANT:
DO NOT force the thermocouple connector
into its jack. The connection tabs are different sizes, allow
-
ing the connector to fit in only one way.
4. Push the optional ambient/primary-air thermocouple into the T-AIR
jack.
Summary of Contents for 0024-8252
Page 54: ...Fyrite INSIGHT 50...