2
3. Run the recommended double insulated line set from the condensing unit to the evaporator
opening (50 foot max.).
4. Power from disconnect (recommended) 12-2/with ground to the condensing unit.
5. Check low pressure control for the correct 25 psi setting, with a 15 psi differential.
Diagram 1
Evaporator Set Up
1. Locate a suitable ceiling mount location, as close to the middle of the room as possible.
Allow for at least 24 inches from the back of the evaporator (coil side) to the back wall for
adequate air distribution.
2
. Run the 1/4” drain line from the pump in the evaporator through the ceiling cap and
out to a suitable location. Heat tape any portion susceptible to freezing..
3. Attach template to the ceiling. Remove the stainless steel outer enclosure from the
base of the unit. Attempt to locate any mounting holes below ceiling joists for secure
attachment with (#8) wood screws. Use moly bolts for all other mounting locations.
Attach base securely to the ceiling. (diagram 1) Minimum 7 mounts.
4. Bring in power (14-2/with ground) to an approved box and connect to wire in harness
outside evaporator.
5. Attach template to the ceiling. Remove the stainless steel outer enclosure from the
base of the unit. Attempt to locate any mounting holes below ceiling joists for secure
attachment with (#8) wood screws. Use moly bolts for all other mounting locations. Attach
base securely to the ceiling. (Diagram 1) Minimum 7 mounts
