6
V1.05 Revised 03/16/2021
Figure 1.2.1
Figure 1.2.2
StartUp
-
Turn on the power disconnect and wait until the blue light illuminate. (Figure 1.2.1)
-
Once the blue light illuminate, it means the power is turned on. (Figure 1.2.1)
-
Wait for red blinking on saw stop and carriage stop button. This red blinking means that the
PLC is ready to be operated. (Figure 1.2.2)
-
Press reset button to reset the safety on the machine and the machine is ready to be
operated. (Figure 1.2.1)
Standard Operation
-
Figure 1.3.1 is the operator station to operate the machine. From left to right listed
o
Raise roller
▪
Raise table roller to reduce friction between stone and table. Operator can
easily move the stone once it raised.
o
Lower Clamp
▪
Lower the clamp to make sure the stone is not moving when it’s being
mittered
o
Move left carriage
▪
Move the cutting unit to the left
o
Stop carriage
▪
Stop the movement of the cutting unit
o
Carriage speed
▪
Adjust the movement speed of the cutting unit
o
Move right carriage
▪
Move the cutting unit to the right
o
Start Saw
▪
Start the saw
o
Stop Saw
▪
Stop the saw
