3
See illustration 8 for layout of control unit featuring:
• On/Off button.
• Green movement indicator light.
• Acoustic and visual red alarm light.
• Low battery red warning light.
• Yellow shutdown indicator light
Babysense
is ready for operation and use once the
installation is completed. To operate, follow the below
instructions:
• Place your baby in crib/bed.
• Turn control unit on by pressing On / Off button.
• Make sure red control lights switch on briefly and a
DOUBLE click sound is heard.
• When any movement is sensed, the green
light flashes.
• Acoustic and visual red alarm light are activated if
the baby's movement stops or slows significantly.
• If red low-battery warning light flashes, replace all
batteries as soon as possible. If in addition clicking is
heard, all batteries must be replaced immediately.
• Turn off by pressing On / Off button before taking
your baby out of crib / bed. Make sure the Yellow
shutdown indicator light momentarily blinks and no
other lights are seen thereafter to indicate the device
is turned off.
Due to the high sensitivity of Babysense, fans, wind, air
conditioning, and so forth can influence it. Such
environmental effects could be picked up by the sensors
on a similar level to that of slight movements, thus
preventing or delaying alarm activation.
If the Babysense is concurrently used with other devices,
it is required to conduct the daily performance test
(below) under an environment identical to the actual
situation and while all concurrently used devices are
"ON". Under such conditions, it is required to verify that
the acoustic and visual alarms of Babysense are activated.
Do not conduct performance test by picking up baby
out of bed and waiting for the alarm to sound
• The performance test should be conducted while baby
is not in bed.
• Turn device on and take two steps away from bed.
• Ensure that alarm goes off within 20 seconds (due to
absence of movement).
• The alarm may sound with or without preliminary ticking.
• Check that alarm can be heard in all locations
throughout the home or place of care.
• In case that alarm does not sound within 20 seconds
refer to troubleshooting on page 4-5.
• Performance test must be conducted daily and every
time you move the monitor, change bedding or
relocate crib/bed position.
Isolated cases of false alarms are possible. Check if
caused by faulty connection of the sensor pad(s) to the
control unit, connection of only one sensor pad when
baby can move off the immediate area or failure of the
sensor pads to be directly against the mattress.
In case of false alarms, kindly refer to troubleshooting
guide on page 4-5. If the problem cannot be solved,
please contact manufacturer’s service personnel.
Layout of control unit
Operation
Environmentally caused malfunction
Conduct this performance test daily
False alarms
I
llustration 8
Green movement
movement
indicator light
Red
alarm light
Red low battery
warning light
Hidden On/O
ff
power button
3
User Guide
Yellow shutdown
indicator light
8.
Press control unit holder or hanging hook firmly into
slot in back of control unit (see illustration 4 and 5).
9.
Place mattress firmly on top of sensor pads. If the
mattress cannot be in contact with the sensor pads, or if
the bed base is soft, padded or contains springs, place
extra plywood on the bed base, place the sensor pads on
the plywood and place the mattress firmly on top.
IMPORTANT:
To avoid possible danger from sensor
cords, ensure that excess cords are pulled back under
the mattress, secured with the included cable tie and
are not visible or reachable.
Testing Operation
Technical malfunction
Babysense
is a highly sensitive device, which monitors a
baby's motion and movements through the mattress
during sleep. There are two main causes of malfunction -
technical malfunctions and malfunctions due to
environmental factors.
In order to minimize technical problems, follow
installation and operation instructions carefully.