2
4.
When using a crib/bed equipped with spring base,
place extra wooden board (plywood) under each sensor
pad, as shown in illustration 3. The recommended size of
the board is at least 17’’ x 11’’ and 1/2’’ thick.
5.
Pass the cord(s) of the sensor pad(s) through special
openings in the holder (see illustration 4).
Cables
Illustration 4
Control unit
holder
Sensor
pads
(Under mattress)
Control unit
Illustration 2
Top crib/bed view
For babies not
yet able to crawl
For crawling babies
Top crib/bed view
Cable
Cable
Bed/Crib
base
Control unit holder
Control
Unit
Illustration 5
Remove batteries when not in use
Sensor
Do not use
Sensor
Slot
Blocked socket
DO NOT USE
“Sensor”
socket
Battery
cover
Opening
recess
Speaker
Illustration 7
Remove batteries when not in use
Sensor
Do not use
Sensor
Slot
Illustration 6
Remove batteries when not in use
Sensor
Do not use
Sensor
Slot
Optional Hanging hook
Plywood
I
llustration 3
Sensor
Sensor
Spring base
Top crib/bed view
User Guide
6.
Attach end(s) of the cord(s) to the outlets marked
"SENSOR" on the back of control unit
(see illustration 5 and 6). When using one sensor pad,
attach to any “SENSOR” outlet.
PLEASE NOTE:
Do not attach any cable to the blocked
socket, marked "DO NOT USE".
7.
Should the design of the crib / bed not allow proper
installation with the control unit holder, please use the
optional hanging hook (see illustration 5) and hang
the control unit from the bottom edge of the crib.