MAINTENANCE OF THE BLADE
Always apply oil to the blades before use. This will ensure maximum
cutting performance. With the clipper switched on, away from your
body in a downward position, apply oil onto the top of the blade. Turn
clipper off and wipe off excess oil with a soft dry cloth.
REPLACEMENT AND REMOVAL OF BAB685U BLADE SET
To remove the blade: turn the clipper to the off position and unplug
from mains supply.
To replace the blade after removal for cleaning, replacement, or
because they are out of alignment;
• Place the moving blade onto the plastic oscillating head.
• Next, you must make sure that the two blades are properly aligned.
• Line up the non-moving blade with the two screw holes.
• Replace the original screws, and lightly tighten. Then align the two
blades up, point to point, as per figure 4 below.
• The top blade teeth (larger blade) should be 1mm above the bottom
blade (smaller cutting blade). This is important so that the clipper
does not cut too close, or come in contact with the skin as this may
cause injury.
• The extreme left-hand tooth of the top non-moving blade must cover
or be to the left of the first small tooth on the moving supply blade.
• Be sure to add a few drops of the oil included with the clipper to the
blades before running.
IMPORTANT:
You must tighten the screws after the blades have been
aligned.
Non-moving
blade
Moving
blade
1mm
1mm
