ASSEMBLY:
•
Remove stroller from box. The front wheel, rear wheels, fender, child tray
and parent tray need to be installed prior to use.
•
To attach the front wheel, unfold stroller as described in the section
following. See figure 1.
Lean the stroller backwards so that it rests on the handle and rear axle frame
and the front wheel forks are pointing upward.
The front wheel features a quick release attachment system. See figure 3.
Slide the front wheel onto the front forks. See figure 2. The quick release
must be loose enough for the wheel to slide on and the brake release lever
must be in the open position (see figure 6). Line up the tab on the Holding
Plate with the slot on the fork plate. With the wheel in position, tighten the
finger nut on the axle until it is very close to contacting the fork. See figure
4. Rotate the lever to the closed position as shown in figure 5. You should
feel significant resistance when closing the lever and the wheel should be
held tightly. If you do not, open the lever and tighten the finger nut a bit
more and close the lever again. Continue to do this until the wheel is held
tightly in the fork. Close the brake release lever by rotating it toward the
front of the stroller. See figure 6.
• The front fender is secured to the frame by the 5 screws provided. Examine
the bottom of the front fender. You will notice four
1
/
4
inch diameter plastic
tubes protruding from the bottom. See figure 7a. These tubes must be lined
up with the holes in the front frame assembly. See figure 7b. Line up the
front fender and press onto the front frame assembly. See figure 7c. Insert
the 5 screws through the underside of the front frame assembly into the front
fender's plastic tubes. Tighten the screws only until snug. See figure 7d.
Do Not over-tighten.
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
Ring
Figure 1.
Figure 2.
Figure 3.
3
Front Wheel
Rear Wheels
Stroller
Fender Screws
Parent Tray
Fender
Child Tray
