Page
17
Babylock.com
Changing the Hopping Foot
Your machine comes with two hopping feet: a ruler foot and an open-toe foot. Use the ruler foot for ruler work and
everyday quilting, and the open-toe foot when you need greater stitch visibility (such as micro quilting).
1. Remove the foot that is on the mount by using the
2.5mm Allen wrench to loosen the mounting screw
far enough that you can slide the foot off of the
mount.
2. Slide the desired foot onto the mount (Figure 9). Note
that the opening on the side of the foot is lined up
with the screw hole. Push the foot up as far as it will
go�
3. Ensure the middle of the foot opening is centered
with the needle when the foot is fully tightened with
the 2.5mm Allen wrench. If it isn’t properly centered,
loosen the lock nut; center the foot with the needle;
hold the foot in position; and firmly tighten the lock
nut (Figure 10).
Figure 10
Figure 9
Summary of Contents for Tiara III BLTR16-3
Page 1: ...3 ...
