Page 14
Baby Lock Tiara III Instruction Manual
Installing the Power Cord
Check that the On/Off switch (see page 12, Figure
4, #25) is turned off (the 0 setting). Plug the power
cord into the top power outlet on the back of the
machine (Figure 5). Do not plug the power cord
into an electrical outlet at this time.
The accessory power connector (see page
12, Figure 4, #27) is available for powering
future attachments as they are developed by
manufacturer. (Not yet available.)
Figure 5
Installing the Foot Pedal
1. Plug in the foot pedal cord end into the foot pedal connector (see page 12, Figure 4, # 28).
2. Place the foot pedal under the table where operator can reach it from the front of the machine.
Installing the Thread Antennae
Figure 6
Locate the threaded hole on top of the machine near
the rear by the handwheel.
2. The thread antennae comes with a washer and a nut.
Remove the nut and washer, replace the nut onto the
antennae and tighten for two or three turns.
3. The washer protects the painted surface when the nut
is tightened. Place the washer on the hole and insert
the thread antennae.
4. Turn the thread antennae clockwise several
revolutions, stopping when the antennae eyelets are
positioned directly over the spool pins.
5. Tighten the nut to secure the thread antennae to the
machine.
NOTE
: The eyelets of the thread antennae MUST
be centered over the spool pins. This ensures
that the thread cone will not pull, turn or tilt,
which will cause thread tension problems (see
Figure 6).
Summary of Contents for Tiara III BLTR16-3
Page 1: ...3 ...
