![background image](http://html.mh-extra.com/html/baby-lock/evolution-ble8w-2/evolution-ble8w-2_instruction-and-reference-manual_462444012.webp)
O
V
E
R
V
I
E
W
10
Your machine is pre-set to sew an overlock with a chain stitch. The upper blade is engaged to cut the fabric
while sewing. Of course, you may select to engage or disengage the cutting blade. You can change the blade
cover to the sewing table and lock the upper looper down when sewing only the chain stitch.
M
6.0
3.5
3.0
5.5
LOCK
A
B
C
E
D
Cutting Blade Lock Switch
Cutting Blade Cover and Sewing Table
Upper Looper Positioning Lever
To lock cutting blade down:
Turn the dial clockwise 180 degrees to see "LOCK" on the top.
The cutting blade will stay below the needle plate for non-cutting
techniques (fig. A).
To re-engage cutting blade:
Turn the cutting blade lock switch half of a turn counter-clockwise. The blade
will start moving automatically when you start sewing.
Cutting blade cover can be changed to sewing table for chain/cover stitching
a) Open front cover and cutting blade cover (page 9, fig. F & G).
b) Gently pull toward you to unsnap cover (fig. B) and snap sewing table into
place (fig. C).
c) Lower the upper looper positioning lever down (fig.D).
d) Close the sewing table door and then the front cover (fig. E).
When you change from overlocking to chain/cover stitching, you should also
change the upper looper positioning lever to the "DOWN" position before you
close the sewing table door.
a) Turn the handwheel until upper looper is at its lowest position.
b) Change the upper looper positioning lever to the "DOWN" position (fig. D).
c) Close the sewing table door and then the front cover (fig. E).
Note:
Make sure the upper looper positioning lever is in the "UP" position prior
to locking the machine to thread the upper looper.