O
V
E
R
V
I
E
W
8
Setting Up Your Evolution
1. Remove machine from box
After removing the packing materials from the box,
gently lift your Baby Lock serger by grasping the handle
provided on the top of the machine. Place the machine
on a serger sewing table or any level surface that pro-
vides ample work area to the left. Place the foot con-
troller in a pedal stay, if desired, and place it under the
sewing table.
2. Plug in the machine
Plug the power cord into the machine first, then into a wall
outlet. The power switch is located toward the back on
the right side of the machine. Always make sure the
power is off when the machine is not in use (fig. A).
Available foot controller for U.S.A.: Model YC-482.
3. Polarized plug
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not modify the plug in any
way.
4. Foot controller
The sewing speed of the machine is determined by the
amount of pressure applied to the foot controller. When
not in use, do not place anything on the foot controller,
or the machine could start inadvertently and the con-
troller or motor could burn out.
5. Spool pin extension table
To insert the spool pin extension:
Place the pegs into the slots on the back of the main
thread spool stand.
Push the extension thread stand onto the main thread
spool stand until it snaps into place (fig. B).
To remove:
Hold the back of the extension table with both hands.
Raise it up and out to release from the main thread spool
stand (fig. C).
A
B
C
