![background image](http://html1.mh-extra.com/html/baby-jogger/pram/pram_instructions-manual_3195014004.webp)
2
Peg Perego Primo Viaggio SIP
To install the Peg Perego Primo Viaggio SIP you will need the
following part(s):
2
– Adapter Brackets (
1
– left,
1
– right)
1
– U-Shaped Support Bar
1
– Spring Support Bar
1
– Straight Support Bar
1.
Remove the canopy and seat from stroller frame. Please refer to the
owner manual. (Be sure to store fabric and hardware for later use.)
2.
Secure
Right Adapter Bracket
to frame directly below the
folding mechanism making sure to align the notches in the
Adapter Bracket
over the snap and rivets. (Fig. A)
Repeat to the left side. (Fig. B)
Note:
Do not over tighten. Over tightening will damage the product
and void the warranty.
3.
Before tightening
Left Adapter Bracket
to frame, align the
Straight Support Bar
into
Adapter Bracket
hole. (Fig. B)
Once in place tighten
Left Adapter Bracket
. (Fig. B)
4.
Open the compression locks by flipping the Red Latches up to allow
U-Shape Support Bar
to be inserted into
Adapter Brackets
. (Fig. C)
5.
Insert the
U-Shaped Support Bar
with the curved end pointing down
into the
Adapter Brackets
.
6.
Insert
Spring Support Bar
into front of
U-Shaped Support Bar
by squeezing in. (Fig. E)
7.
Place the car seat onto the
U-Shape Support Bar
making sure
that the
Spring
and
Straight Support Bars
engage the locking
mechanisms on the Peg Perego car seat. Adjust
U-Shape Support
Bar
to proper length by sliding
U-Shape Support Bar
in and out.
Use car seat to ensure proper distance. (Fig. C)
Close compression locks by flipping the Red latches down. (Fig. D)
8.
Secure the car seat to stroller using
Safety Belt
. (Fig. F)