6
Britax Companion Car Seat
To install the Britax Companion car seat you will need the
following adapter part(s):
2
– Adapter Brackets (
1
– left,
1
– right)
1
– U-Shaped Support Bar
1
– T-Shaped Support Bar
1.
Remove the canopy and seat from stroller frame. Please refer to the
owner manual. (Be sure to store fabric and hardware for later use.)
2.
Secure
Right Adapter Bracket
to frame directly below the
folding mechanism making sure to align the notches in the
Adapter Bracket
over the snap and rivets. (Fig. A)
Repeat to the left side. (Fig. B)
Note:
Do not over tighten. Over tightening will damage the product
and void the warranty.
3.
Open compression locks by flipping the red latches up. (Fig. B)
4.
Insert the
U-Shaped Support Bar
with the curved end pointing up
into
Adapter Brackets
. (Fig. D)
5.
Place car seat onto
U-Shaped Support Bar
. Adjust
U-Shape
Support Bar
to proper length by sliding frame in and out.
Use car seat to insure proper distance. Close compression locks
by flipping the red latches down. (Fig. E)
6.
Place the
T-Bar
onto car seat as shown and tighten strap using
D-Ring and Velcro. (Fig. F)
7.
Secure the car seat to stroller using
Safety Belt
.
Note:
The Straight Support Bar is not applicable when using the
Britax Companion car seat.
