14
VEHICLE INF
ORMA
TION
2.5 cm (1”)
Sliding Latch Plate and ALR Retractor
A latch plate that slides freely on the belt webbing
and cannot
,
by itself
,
hold the belt snug around a
car seat
.
Slowly pull the shoulder belt all the way out.
Route
the vehicle seat belt through the proper belt path
and buckle it in
.
Then
,
as you pull the vehicle seat
belt tight
,
feed all the slack back into the retractor
.
Grab the sides of the seat at the belt path and slide
the seat side-to-side and front-to-back
.
The seat
should not move more than 2
.
5 cm (1
”
)
.
Sliding Latch Plate and ELR Retractor
A latch plate that slides freely on the belt webbing
and cannot
,
by itself
,
hold the belt snug around a
car seat
.
With this retractor
,
you will need to use the locking
clip to lock the vehicle seat belt
.
Call us at 1-866-774-7177 to order a locking clip
.
Route the vehicle seat belt through the proper belt
path and buckle it in
.
Pull the vehicle seat belt tight
.
While pushing down on seat
,
pinch the two straps
together behind the buckle tongue
.
Unbuckle the
belt without allowing it to slip
.
Attach locking clip to lap and shoulder belts as
shown
.
Rebuckle belt
.
Check that lap belt does not move
by pulling hard
.
If belt loosens or lengthens
,
repeat
procedure
.
