♦
String tensioning
Once the racket has been properly installed and the clamp(s) adjusted, refer to the stringing
recommendations of the racket manufacturer and enter the tension value of the string
(TENSION) on the control panel.
To tension the string, thread it through the
pulling unit. At this point you should make a
precise movement: bring the string towards
you, and without letting it go, lightly touch
the "cycle start" button. This precise
movement is something you should get used
to very quickly.
After the pulling head is activated, the pulling
unit closes itself over the string. Let go of the
string. When the required tension is reached,
use the 3-tooth clamp to maintain the
tension of the stretched string. Lightly touch
the "cycle start" button again. The pulling
head will return to its initial position and the
pulling unit will open up and release the
string.
When the pulling head arrives at its end of travel
without the tension being reached, the buzzer
goes off to indicate that the tension is not
correct.
NB:
the measuring system on your SENSOR stringing machine is automatically adapted to
the elasticity of the string (gut, synthetic, Kevlar
®
, etc.).
24
