baalbaki SPA-218, Instruction Manual

Page: 6 / 8

04
1.3 Technical Characteristics
**
The Frequency will in accordance with the motor that the machine
shall be equip.
Table - 01
Characteristics Unit SPA-218/218L
Voltage
Power Rating
110 / 220
50 ou 60 (*)
0,55 ou 0,73
1500
625
640
67
82
260x263
2180
0,75 ou 1
V
Hz
CV
kW/h
mm
mm
mm
mm
mm
kg
kg
Frequency
Consumption
Height
Width
Depth
Net Weight
Gross Weight
Height x Cutting- Max. X Width
Blade Lenght
2 INSTALLATION and PRE OPERATION
2.1 INSTALLATION
The bone saws must be installed over a firm working floor.
Check the electric network voltage, if it is 110 or 220 V. Following, settle the
machine according to the network voltage through the voltage selector switch,
located inside the machine through the rubber cover in the back of the machine.
The electric cord has two round pins and one earth wire. It is obligatory to
have the 3 properly connected before using the machine..
2.2 PRE OPERATION
First of all check if the Band Saw is firmly standing in its position . Before
using it clean the Blade Nº 05, Wheels Nº11 and Nº12 and Doors Nº 03 and Nº 09
(Pic.01), with water and neutral soap .
To adjust (stretch) the blade Nº 05 (Pic.01), turn clockwise the Blade
Stretching Knob Nº 01 (Pic.01).
IMPORTANT
Be sure that the Blade Nº 05 (Pic.01) has the right tension before operating
the saw, by turning clockwise the Blade Stretching Knob Nº01 (Pic.01).
09
4.4 Operation
4.4.1 Advice
Be sure your hair is not loose in order to avoid getting caught by turning parts
which could lead to a serious accident. Tie your hair well up and/or cover your head with
a scarf.
The operation performed by not trained or skilled personnel shall be forbidden.
Never touch turning parts with your hands or in any other way.
NEVER operate machine without all original safety devices under perfect
conditions.
4.5 After Finishing The Work
4.5.1 Precautions
Always TURN THE MACHINE OFF by removing the plug from the socket before
cleaning the machine. Never clean the machine unless it has come to a complete stop.
Put all components back to their functional positions before turning it ON again.
Check level of oil. DO NOT place your fingers in between belts and pulleys nor
chains and gears.
4.6 Maintenance
4.6.1 Danger
Any maintenance with the machine in working situation is dangerous. TURN IT
OFF BY PULLING THE PLUG OFF THE SOCKET DURING MAINTENANCE.
4.7 Advice
Electrical or mechanical maintenance must be done by qualified personal for
such operation.
Person in charge has to be sure that the machine is under TOTAL SAFETY
conditions when working.
5 Analysis and Problems Solving
5.1 Problem, causes and solutions
The Band Saws have been designed to need minimum maintenance, however,
some performance failures may happen due mainly to natural worn out, caused by the
use of the Saw.
If some problem arises with your Bone Saw, check Table - 02 in the next pages, where there
are detailed some possible solutions.
Besides, the Company is ready to assist you through your Dealer or Authorized Technical
Assistance (Check the attached list of authorized Technical Assistance).