CUSTOM FOCUSER
START
– The self-learning Position Calibration will
move the focuser outward till a 25mm trip is reached.
CALCULATE
– When the motor has stopped, the
absolute 25.00 mm position will be displayed. Adjust
this value by typing the effective trip measured.
GEAR RATIO SUGGESTED
– This is the gear ratio of
the focuser calculated by SteelGo.
TYPE MAX TRIP [MM]
– Type the effective trip
measured into the SteelDrive device.
TYPE GEAR RATIO
– Enter here the gear ratio of the
focuser.
PLEASE NOTE:
These options are only available if you
selected CUSTOM as focuser model.
For all
Steeldrive Diamond models, you must select
"CUSTOM" and enter 0.2291 as Calculated Gear
Ratio. At "Type Max Trip", please enter 30, 40 or
80mm, depending on the model.
OTHER FUNCTIONS
SELECT FOCUSER MODEL
– Set the proper model of the SteelTrack focuser.
SLEW RATE
– Adjust the max speed with GoTo and manual movement with UP and DOWN
buttons.
ACCELERATION RAMP
– Adjust the speed profile when the SteelDrive is speeding up.
WRITE –
Push this button to send any new value with T COMPENSATION, SLEW RATE and
ACCELERATION RAMP to the SteelDrive device.
VIRTUAL COM PORT
– Select the COM Port where the SteelDrive is plugged in.
Important Note: ALL THE CHANGES WILL ONLY TAKE EFFECT WHEN WRITE BUTTON IS
PRESSED