B9Creations Core Series Printer User Manual Rev. A-3
04-14-2020
A.
Vat Clamp Plates
B.
DuraVat
C.
Arm Assembly
D.
Lock Knob (part of “E”)
E.
Build Table Assembly
F.
Green Line on Entry Label
9.10 Inserting and Positioning DuraVat
NOTE
Inspect material and DuraVat for contaminants prior to use. DO NOT USE MATERIAL THAT CONTAINS
CURED PARTICLES, CURED PIECES, PARTS OR CONTAMINANTS. Material can be filtered by the operator
using components provided in the Finishing Kit.
Use a fresh, clean, re-charged DuraVat to begin each print. See “Vat Recharging Process” in section
10.1.4
.
Fill the DuraVat with only clean, approved material. Pour clean material to the “Max Fill” line indicated in
the DuraVat reservoir.
NOTE
Do not overfill DuraVat. Overfill of the DuraVat will cause material spillage in the build chamber.
Slide DuraVat into printing position in the build chamber. DuraVat flanges should slide under vat clamp
plates. Slide in DuraVat until it snaps into place, and
the green line on the Entry Label is visible
.
9.11 Inserting and Securing Build Table
Slide the Build Table (B) slot into position on the Arm
Assembly inside the Build Chamber until the Build Table hits
the end of travel on the Arm Assembly. Once seated on the
Arm Assembly properly, secure the Build Table on the Arm
Assembly by hand tightening the Lock Knob (A). Turn the Lock
Knob clockwise to tighten until the Build Table does not
wobble. Do not over-tighten Lock Knob.
NOTE
Do not attach the Build Table to the Arm Assembly at the screw threads beneath the lock knob or DuraVat
damage will occur.
NOTE
A
E
D
C
B
F
B
A
