76
port. Windows will automatically assign a
COM port to the instrument. Please verify
which COM port Windows has assigned by
going into “Device Manager”.
USB (Virtual COM) Configuration
The USB will be recognized as a virtual COM on the
PC, thus serial port settings must be configured
properly for remote communication to be successful.
Below are the default settings used by the 830C and
890C meters. They can be changed within the setup
menu. See SETUP OPTIONS section for details.
•
Baudrate:
9600
•
Data bits:
8
•
Parity:
None
•
Stop bits:
1
•
Flow Control:
None
Remote Mode
Upon connecting to the instrument, sending any
commands listed in the “Command Protocols” section
will automatically set the meter into remote mode. In
remote mode, the LCD display will show the
RMT
indicator.
Summary of Contents for 830C
