40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
Phase 1 - Rough In
Installation of Back box
1. Install conduit and junction box (by others) to
be used with this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire
• Rated for 90° C.
Please refer to the low voltage design guide at www.bklighting.com/
lvguide before installation for proper wire selection.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
3167387
ETL LISTED
CONFORMS TO ANSI/UL STANDARD 1838,
CERTIFIED TO CSA STD C22.2 NO.250.7
CSA STD C22.2 TIL B-58A
RELEASED
12-12-11
REFERENCE
NUMBER
INS000971.1
120V
12V
FIXTURE
COM
GROUND
Transformer
COM
GROUND IN T-HOUSING
Wiring Diagram
Phase 2 - Finish Installation of Fixture with Power Canopy.
1.
Remove one or two wire entrance knockouts on
wall plate. Pull primary branch circuit through
knockout(s). Attach wall plate to junction box
using appropriate hardware (By Others).
2. Ground primary branch circuit to wall plate
per NEC. Make two connections from remote
12V transformer to primary branch circuit
using proper wire connectors. (By Others).
See wiring diagram.
3. Connect fixture to transformer with provided
quick disconnect.
4. Mount canopy to wall plate using four (4)
#8-32 stainless steel button head screws with
5/64” allen wrench. Do not over tighten.
4. Use 5/32” allen wrench to loosen #10-32
stainless steel black oxide socket head cap
screw at the knuckle. Aim fixture to desired
vertical location. Tighten to secure aiming
position.
5. Use 5/64” allen wrench to loosen stainless steel
set screw on the 360SL™ rotational mounting
system and rotate to desired horizontal
location. Tighten to secure aiming position.
PROJECT:
TYPE:
SIGN STAR™ AND TWIN SIGN STAR™
Sign Lighting Installation Instructions
TECHNOLOGY
with