40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
PROJECT:
TYPE:
Phase 1 - Rough In
Installation of Back box
1. Install Conduit and Junction Box (by others)
to be used with this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
Please refer to the low voltage design guide at www.bklighting.com/
lvguide before installation for proper wire selection.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
3167387
ETL LISTED
CONFORMS TO ANSI/UL STANDARD 1838,
CERTIFIED TO CSA STD C22.2 NO.250.7
CSA STD C22.2 TIL B-58A
RELEASED
12-12-11
REFERENCE
NUMBER
INS000971
SIGN STAR™ AND TWIN SIGN STAR™
Sign Lighting Installation Instructions
LINE
12V
FIXTURE
COM
Remote
Transformer
(by others)
COM
Wiring Diagram
Phase 2 - Finish Installation of Fixture with Remote Transformer.
1. Install universal mounting ring (supplied with
fixture) to junction box using appropriate
hardware (By Others). Align canopy mounting
holes to final mounting position.
2. Make two connections from remote 12V
transformer to LED source leads (18 gauge
wire) using proper wire connectors (By Others).
See wiring diagram.
3. Mount fixture canopy using two (2) #10-24 hex
screws using 1/8” allen wrench. Do not over
tighten.
4. Use 5/32” allen wrench to loosen #10-32
stainless steel black oxide socket head cap
screw at the knuckle. Aim fixture to desired
vertical location. Tighten to secure aiming
position.
5. Use 5/64” allen wrench to loosen stainless steel
set screw on the 360SL™ rotational system and
rotate to desired horizontal location. Tighten to
secure aiming position.
TECHNOLOGY
with
