40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
PROJECT:
TYPE:
3. Mount fixture using two (2) #10-24 hex screw
to installed back box. Do not over tighten.
Phase 2 - Finish Installation of Fixture with Transformer in Junction Box.
LINE
12V
FIXTURE
COM
Remote
Transformer
(by others)
COM
1. Ground primary branch circuit to junction box
per NEC. Remove #10-24 Stainless Steel Phillips
screws from mounted back box. Install universal
mounting ring (supplied with faceplate) using
#10-24 screws onto back box. Align faceplate
mounting holes to final mounting position.
2. Make two connections from 12V transformer
to LED source leads (18 gauge wire) and two
connections to primary branch cuircuit using
proper wire connectors (By Others).
Phase 1 - Rough In
Installation of Back box
1. Install Conduit (by others) to be used with
this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• 4” round cast box is provided with Five (5) 1/2” threaded hubs
for conduit entry (4 on sides and one on back of box).
• Suitable for through wire
• Suitable for installation into combustible materials.
• Rated for 90° C.
Please refer to the low voltage design guide at www.bklighting.com/
lvguide before installation for proper wire selection.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
3167387
ETL LISTED
CONFORMS TO ANSI/UL STANDARD 1838,
CERTIFIED TO CSA STD C22.2 NO.250.7
CSA STD C22.2 TIL B-58A
EC™/ ED™/ AS™/ SM-AR™
Architectural Surface Installation Instructions
PRELIMINARY
7-11-12
REFERENCE
NUMBER
INS000942
3. Mount fixture using two (2) #10-24 hex screw
to installed back box. Do not over tighten.
Phase 2 - Finish Installation of Fixture with Remote Transformer.
1. Remove #10-24 Stainless Steel Phillips screws
from mounted back box. Install universal
mounting ring (supplied with faceplate) using
#10-24 screws onto back box. Align faceplate
mounting holes to final mounting position.
2. Make two connections from remote 12V
transformer to LED source leads (18 gauge
wire) using proper wire connectors (By
Others).
TECHNOLOGY
with