ArtiStar™ GU10
Wall Mount Installation
RELEASED
1-26-17
REFERENCE
NUMBER
INS131800.1
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING
IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
Fixture Installation
Phase 1 - Rough In
Installation of Back box
1. Install Conduit and Junction Box (By Others)
to be used with this product.
2. Install junction box so that front face is flush
with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting hardware
and gaskets (By Others)
1. Install universal mounting ring (supplied with
fixture) to junction box using appropriate
hardware (By Others). Align canopy mounting
holes to final mounting position.
Phase 2 - Finish Installation of Fixture
WIRING DIAGRAM
LINE
FIXTURE
COM
GROUND
LINE
COM
GROUND
2. Make watertight connections using
waterproof wire connectors (By Others).
Connect incoming ground wire to ground
wire provided in fixture body. See wiring
diagram.
All line voltage connections must be made
in compliance with the National Electrical
Code. Failure to do so will void warranty.
4. Use 3/16” Allen wrench to slightly loosen
¼”-28 stainless steel black oxide socket head
cap screw at the knuckle for vertical aiming
purposes. Use 5/64” Allen wrench to loosen
the three (3) #8-32 stainless steel set screws.
Rotate to aim fixture to desired horizontal
location.
5. Tighten the three (3) #8-32 stainless steel set
screws and 1/4”-28 stainless steel black oxide
socket head cap screw at the knuckle to secure
all aiming positions.
3. Use 1/8” Allen wrench to mount fixture with two
(2) #10-24 hex screws to installed back box. Do not
over tighten.