AB-7350-U
24
Attach.
Lead the wires.
3) Connect the seal connectors (optional) to the cover of the cable gland.
IMPORTANT:
When tightening a seal connector to the cover, be sure not to press excessive force on the latches.
Figure 31. Connecting the seal connectors onto the cover of the cable gland
4) Strip the cable sheath long enough for connecting to the terminals of the product.
IMPORTANT:
Be sure not to scratch the insulated wires.
Adjust (cut) the wires (sheath stripped part of cables) in accordance with distance from the cable gland and each terminal/
connector.
Sheath strip length is 7" (178 mm) or longer. Change the strip length of the cables in accordance with distance from the
cable gland to each terminal/connector to facilitate connecting wires.
5) Loosen the cap of a seal connector. Let the wires through the seal connector so that the end of the sheath comes to inner
side of the cover. Then, tighten the cap of the seal connector to fix the cable.
Figure 32. Wires through the seal connector
6) Lead the wires (sheath stripped part of cables) through the wiring port (where the base of the cable gland is attached) of the
product. Then, attach the cover of the cable gland to the base.
IMPORTANT:
Carefully attach the cable gland so that O-rings do not fall from the cable gland. Without the O-rings,
water-proof protection is not assured.
Figure 33. Attaching the cover to the base
Seal connectors
(optional)
Cover
of the cable gland
Loosen.
2. Tighten.
Wires (sheath stripped part)
1. Insert.
Cable
Cables
Seal connectors
Wires
Pass through the wires until the end of the sheath comes to inner side of the cover.
