ULTRA-QUICKSTART GUIDE
1
These minimized directions are intended for more knowledgeable or experienced installers, or just for
the impatient. Turn this booklet over for more in-depth instructions, and see https://
support.ayrstone.com for additional information.
Turn over for more in-depth instructions
GET READY: Write down the MAC address of the Receiver in the box below
and put it someplace safe. If you haven't already, create an account on
AyrMesh.com from a computer connected to the same router that the
Receiver will be connected to. This ensures you won't have to enter the
Receiver's MAC address manually.
2
ASSEMBLE: If you haven't already, open the door on the bottom of the Receiver, exposing the
Ethernet ports.
3
INITIALIZE: With an Ethernet cable, connect the LAN port of
the
Power Supply to your router. With another Ethernet cable,
connect
the PoE port of the Power Supply to either port on the
bottom of the Receiver. Plug in the power supply (lights on the
Receiver will go on). Wait until
the Receiver checks in to
AyrMesh.com - the signal lights will "run" from bottom to top,
then the top signal light will remain lit. This should take about
a minute.
4
INSTALL: Mount the Receiver outdoors, high and "in the clear."
Run a long
(preferably shielded - STP) Ethernet cable from the
power supply (which must be kept dry) to the Receiver -
remember to leave a "drip loop" where the cable enters the
building to prevent
water from coming down the cable inside.
See http://support.ayrstone.com for additional information, hints, and
troubleshooting tips.
Drip
Loop
20:0D:B0:00:00:00