Signal lights on the ReceiverC
5
Top Signal light
Third Signal light
Second Signal light
First Signal light
Wireless light
LAN light
WAN light
Power light
The Power light should be on steady and the
signal lights indicating signal strength as
shown:
No lights - no signal
First Signal light - very weak signal
Second Signal light - fair signal
Third Signal light - good signal
Fourth Signal light - very strong (may be
too close)
Using the ReceiverC
6
To Receiver
To Receiver
Power
Supply
PoE LAN
Power
Supply
PoE LAN
Computer,
WiFi Access
Point, etc.
Ethernet Switch -
plug devices into
open ports
To Power
Supply
IP Camera or
other outdoor
device
Using the AyrMesh Receiver is extremely simple: just
plug whatever indoor device you want to have join your
network into the "LAN" port of the Receiver's power
supply. For instance, to connect a computer or other
device to the AyrMesh Receiver, just run an Ethernet
cable from the camera to the Receiver's Power Supply
LAN port. You can also connect an Ethernet Switch to
provide additional ports. To use the Receiver to
connect an outside device, just connect it to the open
Ethernet port on the bottom of the Receiver. NOTE:
the Receiver does NOT provide power (PoE) for
external devices.
DO NOT TRY TO USE A ROUTER FOR INDOOR
WIFI. A second router will commonly cause an IP
address con ict, bringing your entire network to a
halt. A wireless router can be used this way, but it must
be con gured in "access point" mode (if available) or
with a separate IP subnet.