To enter the advanced setup mode, make sure that
the amplifier is in the system-sleep state (green LED
illuminated on the right-hand button). Then press
and hold the left-hand button for three seconds.
This enters the unit into the basic setup mode. The
display will briefly show “
SET UP
” and then
display “
XXX 1
” where “XXX” is the name
assigned to input 1.
Use the right-hand knob to select which input
(
1 - 6
) you wish to configure with advanced options.
Then briefly press the right-hand button to enter
the advanced menu level. The left-hand knob will
select which setting you wish to configure for that
input:
•
CN
- Custom Name
•
GOS
- Gain Offset
•
PP
- Processor Pass-Through
•
AL
- AyreLink
•
RST
- Reset
After you have selected the desired choice, press the
right-hand button to enter the selection.
18
XXX
1
SET
UP
CN
GOS
PP
AL
RST
