It is possible to adjust the built-in patterns and to add several effects, such as zoom-effects or pattern
rotation.
NOTE:
When the DMX-signal or master/slave signal is lost (due to a failure in the DMX-connection or any
other reason), the laser will shut off the output due to safety issues. This prevents the projection of static
images and/or patterns.
Placement and mounting of the fixture:
For safety reasons, the ITA ERO Laser is equipped with a laser diode of the type ‘fat beam’. This means, the
diameter of the laser beam is much thicker than a regular laser beam, to spread the intensity of the laser
beam on a larger surface. Therefore, the intensity of the laser beam is lower than a regular laser, projecting a
static dot on a surface. This prevents injury when the beam is projected into your audience (however, Ayra
does not recommend this kind of use).
The used laser diode is an 80 mW green fat beam diode. The diameter of the projected beam is 10mm.
The fixture can be placed on a solid surface with the rubber feet. When using the fixture in a hanging
position, the included mounting bracket must be used and the safety eye must be mounted. The fixture must
be installed by mounting a proper bolt or hook to the bracket. Use a safety cable on the safety eye to make
sure the fixture can not fall down. This prevents possible damage and severe injury. The safety cable must
be capable of holding at least 10x the weight of the fixture.
The fixture must be positioned in such a way that the distance in height is at least 1.5m from the audience.
This prevents solid beam projections in the audience for longer periods of time. Projection into your audience
is not recommended, but will not cause any harm when the installation requirements are met.
The ERO Laser fixture can be mounted in almost every position, including horizontal or upside-down. Use
proper installation hardware, such as half couplers for truss systems.
