![background image](http://html1.mh-extra.com/html/ayra/9000-0051-4484/9000-0051-4484_user-manual_3042290009.webp)
Installation and Connection Requirements
Now that you know how the UV LED Brick works, it's important to know how to use it correctly and safely,
according to the installation and connection requirements.
Make sure the device and connection cables are out of reach of children, and that if children are present,
they are under adult supervision at all times. Because this device can be used upright or suspended,
children could pull on the cables, causing the device to fall on top of them. To avoid injury, it is important to
pay close attention to the position and/or installation of this device.
Upright use
If you wish to use the UV LED Brick in upright position, ensure the device is placed on a stable surface like a
table, DJ booth or bar. The UV LED Brick has not been equipped with rubber feet, so make sure it can’t
topple over when someone trips over its cables.
Suspended use (brackets)
If you wish to use the UV LED Brick in a suspended position, use the included suspension bracket,
tightening knobs and rubber rings to mount it.
The rings are placed in between the bracket and the armature. Tighten the knob on each side to firmly fix the
bracket in place.
If you want to mount a half coupler or a G-hook to the brackets, it is advised to do this before mounting the
brackets to the armature. You can find standard hooks and/or brackets for 35 or 50mm tubes (truss or light
stand) at your local dealer.
Hardware for mounting the UV LED Brick to a wall, ceiling, or beam is not included. Contact a specialist if
you're not surewhich hardware is required for your situation. A wooden beam and stone wall require different
mounting methods.
Should you want to suspend the UV LED Brick, you will need to attach a safety cable to the armature. This is
not included, but is available at your local dealer. The UV LED Brick is equipped with an eyelet for hooking a
safety cable. Once it's hooked on, you can wrap the cable around the truss or light stand and attach it again
by means of the same hook. This ensures the device is secured and prevents it from falling, even if one or
both of the brackets should come loose.
Ensure that the safety cable has a load capacity of 10x the weight of the armature and that the device can
not fall farther than 30 cm. You can wrap the safety cable around the truss or light stand several times to
ensure the fall is as short as possible. The shorter the fall, the less chance of damage or injury.
Light source
The UV LED Brick features powerful LED modules, bundled by a special reflector. Never look directly into
the lens at close range, as the human eye can't adjust to the sudden intensity of the beam of light this device
produces. It won't result in permanent damage, but it can cause temporary blind spots, which may cause
disorientation and discomfort.
Parts and repair
This product does not include spare parts and can not be repaired by the user. All inspections and overall
maintenance should be done by a specialist.
Cleaning and maintenance
Clean the exterior of this device monthly with a dry, or slightly damp microfibre cloth. Ensure that the device
is unplugged before cleaning it.
Check if all the screws are intact and secured and tighten or replace them where needed. Check all metal
parts of the device for any signs of corrosion. If corrosion is found, the device needs to be checked
thoroughly.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:07-10-2019 RV
Revision date and author's initials: -