Fog machine troubleshooting
If you have any problems with your fog machine, consult this troubleshooting section to solve any difficulties
with your product. If this troubleshooting section does not solve your problem, contact your dealer for more
information and help.
This troubleshooting section contains the most frequent problems and is not a complete collection of possible
faults, defects and solutions. The troubleshooting section applies to Ayra WSM fog machines. It is possible
that not all the described problems, causes and solutions apply to your situation as product details may vary
from product to product.
Problem
Possible Cause
Solution
The machine is turned on with the
on/off switch, but is not powered.
Blown fuse
Check the fuse compartment for
blown fuses and replace it if
necessary. Always disconnect the
machine from any power sources
before checking the fuse!
Power cable not connected
Connect the power cable to your
machine and a wall outlet or power
strip.
Power cable broken
Disconnect the machine and
unplug the cable immediately from
the wall outlet or power strip.
Power source not active
Check your power source (wall
outlet or power strip) and make
sure there is an accurate voltage
provided for the machine.
Fog machine heater is not active
No power
Check the power indicator light on
the switch. If not lit, the machine is
not turned on.
Heater broken
Contact your local dealer for help
and support.
No fog produced
Fog liquid tank empty
Check the fog machine fluid tank
and fill it up if empty.
Fog machine pump or liquid
distribution system clogged
Contact your local dealer for help
and support.
Fog machine heating up
If the LED indicators on the remote
are not lit, the machine is not yet
ready to perform.
Fog machine nozzle sprays hot
liquid drops
Wrong fog machine fluid
Stop producing fog immediately
and check if the right type of fog
fluid is present in the fluid tank.
Heating element or thermostat
broken
Contact your local dealer for help
and support.
Fog machine does not respond to
remote control
Remote control or machine
defective.
If after 10 minutes the machine
does not pass the heating stage
and the LEDs on the machine are
not lit, the remote or the machine
is probably defect.
The information and illustrations shown in this user manual are subject to change without notice.
User manual version: 1.0
Creation date + author initials: 03-11-2015 RV Revision date + author initials: -
